When two moving bodies interact and experience a sudden impact force during their motion, then this event is known as a collision. During the impact, both bodies exert a certain amount of force on each other. This force is known as collision force. Due to the collision, both the bodies change their momentum and energy. In the collision, the determination of velocities can be done with the help of the law of conservation of momentum and the law of conservation of energy.

A collision between two bodies can occur by making actual physical contact and sometimes they donâ€™t make any physical contact with each other but a collision occurs. A collision can be perfectly elastic, inelastic, and perfectly inelastic. In this article, an attempt has been made for giving brief information (like defining collision, defining elastic and inelastic collision, what causes a collision, collision force, types of collisions, line of impact in a collision, etc.).

## What Causes Collisions?

When the collision happens between the two bodies, they interact with each other with a sudden impact force for a shorter duration of time. The major causes due to which the collision occurred between two bodies are given below:

For the collision to happen, the line of the impact of these colliding bodies must be collinear or intersect with each other. The line of impact is the line that passes through the centre of the colliding bodies. If two moving bodies have a common line of impact or intersecting line of impact, then the collision will occur.

When the line of impact is common between the moving bodies and if the velocity of the first body is greater than the second body, then there will be chances of collision and it might be another cause of the collision.

## Types of Collisions

The types of collision are differentiated on the basis of the conservation of energy principle and the direction of colliding bodies before the collision. The types of collisions are categorised under two category which is shown below:

### 1. Based on The Conservation of Energy Principle

In this section, the types of collisions are differentiated based on the law of conservation of energy and conservation of momentum during the collision. There are three types of collisions that are shown below:

Perfectly elastic collision

Inelastic collision

Perfectly inelastic collision

### 2. Based on The Direction of Colliding Bodies

In this section, the types of collision depend upon the direction of the colliding bodies before the collision takes place. Based upon that, the collision is of two types:

One-dimensional collision (or Head-on collision)

Oblique collision

(Video) Zero to Hero in Collisions | JEE Main 2021/22 | JEE Physics | Shreyas Sir | Vedantu JEE Enthuse

## Elastic Collision

In an elastic collision, when a collision takes place between two bodies, then the kinetic energy of two bodies will remain the same. A perfectly elastic collision is an ideal case of elastic collision. For perfectly elastic collision, the value of the coefficient of restitution is one. An example of perfectly elastic collisions is the bounce-back tendency of the ball when it hits the floor.

**Elastic collision**

In a perfectly elastic collision, when two bodies collide with each other, then there is no change occurring in the total kinetic energy of the system. It means that there is not any transformation of energy occurring in the form of heat, noise, etc. It is a special case of elastic collision.

The collision formula of perfectly elastic collision is shown below:

In the given figure (image 1), the first body of mass m1 with velocity u_{1} strikesthe second body of mass m_{2} moving with velocity u_{2}. After the collision, the first body moves with v_{1} and the second body moves with v_{2}. As the total momentum is conserved, then the initial momentum of both the bodies P_{1}+P_{2} will be equal to the final momentum of both bodies P_{1}â€™+P_{2}â€™.

$p_{1}+p_{2}=p_{1}^{\prime}+p_{2}^{\prime}$

The momentums will be,

$\begin{align} &p_{1}=m_{1} u_{1} \\ &p_{2}=m_{2} u_{2} \\ &p_{1}^{\prime}=m_{1} v_{1} \\ &p_{2}^{\prime}=m_{2} v_{2} \end{align}$

$m_{1} u_{1}+m_{2} u_{2}=m_{1} v_{1}+m_{2} v_{2}$ â€¦..(1)

Also for an elastic collision the ratio of the relative velocity before and after collision is equal to 1. This means that,

$\begin{align} &\dfrac{v_{2}-v_{1}}{u_{2}-u_{1}}=1 \\ &v_{2}-v_{1}=u_{2}-u_{1} \\ &v_{2}+u_{2}=v_{1}+u_{1} \end{align}$

We can then write,

$\begin{align} &v_{2}=v_{1}+u_{1}-u_{2} \\ &v_{1}=v_{2}+u_{2}-u_{1} \end{align}$

Substituting the expression for v_{2} inequation (1) gives,

$m_{1} v_{1}+m_{2}\left(v_{1}+u_{1}-u_{2}\right)=m_{1} u_{1}+m_{2} u_{2}$

$v_{1}\left(m_{1}+m_{2}\right)=m_{1} u_{1}+m_{2} u_{2}+m_{2} u_{2}-m_{2} u_{1}$

$v_{1}\left(m_{1}+m_{2}\right)=u_{1}\left(m_{1}-m_{2}\right)+2 m_{2} u_{2}$

$v_{1}=u_{1} \dfrac{\left(m_{1}-m_{2}\right)}{\left(m_{1}+m_{2}\right)}+2 u_{2} \dfrac{m_{2}}{\left(m_{1}+m_{2}\right)}$

Similarly the expression for v_{2} willbe,

$v_{2}=2 u_{1} \dfrac{m_{1}}{\left(m_{1}+m_{2}\right)}+u_{2} \dfrac{\left(m_{2}-m_{1}\right)}{\left(m_{1}+m_{2}\right)}$

These are the expressions for final velocities.

And there is no loss in total kinetic energy of the bodies since it is an elastic collision, therefore initial kinetic energy of both bodies (K.E) will be equal to the final kinetic energy of both the bodies (K.E).

$\begin{align} &(K . E)=(K . E) \\ \\ &\dfrac{1}{2} m_{1} u_{1}^{2}+\dfrac{1}{2} m_{2} u_{2}^{2}=\dfrac{1}{2} m_{1} v_{1}^{2}+\dfrac{1}{2} m_{2} v_{2}^{2} \end{align}$

## Inelastic Collision

In an inelastic collision, when two bodies collide with each other, then there will be some loss in the kinetic energy of the body. In this case, the body gets stuck to each other which indicates that one of the bodies has lost its kinetic energy.

**An Inelastic collision**

An inelastic collision is a type of collision in which the kinetic energy is not conserved but the momentum remains conserved. In the given case, the value of the coefficient of restitution lies between 0 to 1. An example of inelastic collisions is dropping a ball of clay on the floor.

The collision formula for the inelastic collision is shown below:

In the given figure (image 2), the first body of mass m_{1} with velocity v_{1} strikes the second body of mass m_{2} moving with velocity v_{2}. After the collision, the first body and second body move with velocity v. As the total momentum is conserved, then the initial momentum of both the bodies P_{1}+P_{2} will be equal to the final momentum of both bodies Pâ€™_{1}+Pâ€™_{2}

$\begin{align} &p_{1}+p_{2}=p_{1}^{\prime}+p_{2}^{\prime} \\ \\ &m_{1} v_{1}+m_{2} v_{2}=m_{1} v_{1}^{\prime}+m_{2} v_{2}^{\prime} \end{align}$

Since the final velocity of both the bodies are same, then the formulation will be done as,

$\begin{align} &v_{1}^{\prime}=v_{2}^{\prime}=v \\ &m_{1} v_{1}+m_{2} v_{2}=m_{1} v+m_{2} v \\ &\frac{m_{1} v_{1}+m_{2} v_{2}}{m_{1}+m_{2}}=v \end{align}$

A perfectly inelastic collision is a special case of inelastic collision. In this type of collision, when two bodies collide with each other, then both of the bodies get to stick together and move further as a single body. In this case, a large change in kinetic energy is recorded. The value of the coefficient of restitution is 0. The collision formula will be the same as inelastic collision. An example of perfectly inelastic collisions is dropping a ball of clay on the floor.

## One Dimensional (or Head-on) Collision

One-dimensional collision or head-on collision is a case of elastic collision when two bodies move along the same path and the velocity of the first body is greater than the second body collides with each other and after the collision, they move with different velocities. The path of both moving bodies is the same as they move along the straight line joining their centre bodies.

**One-Dimensional or Head-on Collision**

In this collision, the first body strikes the second one and has a head-on collision with the second body. In this encounter, the total kinetic energy of both bodies after the collision will be equal to the kinetic energy of the bodies before the collision which confirmed that there is no conversion of kinetic energy into other forms. An example of a head-on collision is when a car strikes any stationary objects like a tree.

## Oblique Collision

Oblique collision is a type of collision where the first body strikes the other one at an angle before the collision and after the collision, both of the bodies move with different velocities.

**Oblique collision**

In the collision, the line joining the centre of both moving bodies is not the same and their respective line along the centre of the body intersect with each other at an angle. It also belongs to an elastic collision. If both bodies remain in the same plane before and after the collision, then it will be a two or three dimension collision.

The bodies are moving in the x direction initially so the initial momentum of the bodies in y direction will be zero. The momenta will be conserved in both the x and y directions. The conservation of momentum in the x direction will give,

$\begin{align} &m_{1}{u_{1 x}}+m_{2} u_{2 x}=m_{1} v_{1 x}+m_{2} v_{2 x} \\ \\ &m_{1} u_{1}+m_{2} u_{2}=m_{1} v_{1} \cos \theta+m_{2} v_{2} \cos \phi \end{align}$

Similarly for the y direction the law of conservation of momentum will give,

$\begin{align} &m_{1} u_{1 y}+m_{2} u_{2 y}=m_{1} v_{1 y}+m_{2} v_{2 y} \\ \\ &m_{1} \cdot 0+m_{2} \cdot 0=m_{1} v_{1 y} \sin \theta+m_{2} v_{2 y} \sin \phi \\ \\ &m_{1} v_{1} \sin \theta=-m_{2} v_{2} \sin \phi \end{align}$

The coefficient of restitution is the ratio of the final and initial relative velocities. For the x direction this coefficient of restitution can be written as,

$\begin{align} &e=\dfrac{v_{2 x}-v_{1 x}}{u_{2 x}-u_{1 x}} \\ \\ &e=\dfrac{v_{2} \sin \phi-v_{1} \sin \theta}{u_{2}-u_{1}} \end{align}$

These expressions can be used to find the initial as well as final velocities if the parameters are given in the question.

## Conclusion

This article concludes with brief information regarding the concept of collision. The major focus of this article is on the causes of collision, types of collision and defining the concept of line of impact. It also discussed the topics of the elastic and inelastic collision along with the collision formula. For validating and deriving the collision formula, it shares glimpses of the law of conservation of energy and momentum. It also classified the types of collision based on the direction of colliding bodies.

It gives brief information about topics (like defining collision, defining elastic and inelastic collision, what causes a collision, collision force, types of collisions, line of impact in a collision, etc.). This article also defines the concept with diagrams and equations of the different types of collision for a better understanding.